Colormap

Fig. 5B and C and the occupancy time is coded in the trajectory as an increasing green levels (the colormap is the same as in ❋ Carlo E. Villa Et Al. (2010)

There would be no need to resize the colormap and, as you can see with the screenshots, it's possible to live with the halos. ❋ AnnaFan777 (2010)

I think that comes vom mixing the colormap over the greyscale image from the red channel. ❋ Jack-Bauer (2010)

So i thought of the only solution that i could think of as avisynth-noob: I take the green channel from the 2D source, adjust brightness or left and right image, which is a green channel, too (the brightness of the colors should be the same then, is there a plugin to normalize the two sides so they have the same brightness?) and map the colormap of the 2d version over the two images. ❋ AnnaFan777 (2010)

In Chex Quest, uses the radiation suit colormap instead of the red colormaps that are usually used when taking damage (or getting the berserk pack). ❋ Unknown (2010)

The jet colormap used for the images in panels A to C is reported in the figure. doi: 10.1371/journal. pone.0012216.g001 ❋ Carlo E. Villa Et Al. (2010)

TXImage: Using default colormap and visual, TrueColor, depth 24. ❋ Unknown (2009)

The colormap colors in colormapped images are defined using RGBA values, and direct images store 32-bit RGBA colors for each pixel. ❋ Unknown (2009)

Colormapped images define a colormap of up to 256 colors, each represented by a 24-bit RGB value, and then use 8-bit pixel values to index into the colormap. ❋ Unknown (2009)

You will need to formulate and set the correct colormap to use. ❋ Unknown (2009)