Heatsink

There is only one, so I suppose that the software is reporting some other temperature wit the label heatsink wrongly) 2 - Changing the thermal paste will solve unexpected shutdowns. ❋ Unknown (2008)

Um, might wanna be sure your heatsink is below it, and that your fan is up to snuff. ❋ Unknown (2008)

Though the heatsink is a relatively standard affair (take a lump of copper, throw in a few heatpipes and whack some aluminium fins in there), its two fans do a much better job of cooling the card evenly along its length, and also keeping the power regulation under control. ❋ Unknown (2010)

The basic design of the heatsink is the same, packing in six nickel-plated copper heatpipes running the height of the formidable stack of fifty aluminium cooling fins. ❋ Unknown (2010)

I also put a small fan behind my laptop to keep it cool, because as I have learned, I may have a fan and/or "heatsink" isssue. ❋ Haloaskew (2006)

The chipset is cooled by a large low-profile aluminium heatsink which is covered by a plastic plate that carries an illuminated Asus logo. ❋ Unknown (2009)

Furthermore, this fansink also features a skive-fin heatsink which is manufactured to high technical requirements that maximizes heat dissipation and minimizes any chance of overheating. ❋ Unknown (2008)

Any of the claims are plausible, however pulling together a bluetooth or wifi receiver AND speaker, AND light engine AND driver AND heatsink, that put out decent sound and decent light output and color temp. in a package that would replace a standard incandescent or PAR 20 bulb at a price that is under $100 is a tall order. ❋ Unknown (2009)

I wanted to yank the heatsink but it wouldn't come. ❋ Unknown (2009)

I am able to select the best parts and values and pore over every detail from the latencies on the RAM to the cooling pipes on the motherboard and heatsink. ❋ Unknown (2009)

Take off the housing and touch the LED or LED heatsink with your finger and it will burn you. ❋ Unknown (2009)

From the outside shining a flashlight through the vents, it looked perfectly fine, but it was because the dust was trapped on the INSIDE of the heatsink fins. ❋ Unknown (2009)

LEDs need to stay cool to maintain their longevity, so Sero's head is essentially a "pin-fin" heatsink; air flows between the rods, dispersing heat. ❋ Unknown (2011)

Ironically there is an orange piece of "tape" which is plastered over the processor and between the heatsink on every single one i've serviced. ❋ Unknown (2010)

My Dell XPS M1210 failed after 2-3 years due to a poor thermal pipe/heatsink design. ❋ Unknown (2010)

The heat-pipe design maximizes the heat conductivity and the heat is disspiated quickly by the thin blade aluminium fin heatsink. ❋ Unknown (2010)

My Dell XPS M1210 failed after 2-3 years due to a poor thermal pipe / heatsink design. ❋ Unknown (2010)