Knurling

The Bentley etching, known as knurling, can be found in the handle of the computer and the sliding doors that cover the access ports. ❋ Unknown (2008)

The door handles incorporate the traditional Bentley 'knurling' to their inboard surface for enhanced grip, reflecting the company's typical attention to detail, while. the sporting character of the Mulsanne is reinforced by front wing vents and wide oval tailpipe finishers. ❋ Frank Filipponio (2010)

- The cross knurling technique is used for hard rubber, plastic material, etc. ❋ Horst Kth (1990)

By the knurling technique the outer surface of the parts is formed by means of a single-wheel or double-wheel knurling holder. ❋ Horst Kth (1990)

The knurling wheels are made of hardened tool steel and normally have a diameter of 15 - 20 mm. ❋ Horst Kth (1990)

What is the straight-knurling pitch and to which size is the nominal diameter to be turned? ❋ Horst Kth (1990)

Spiral knurling holders have a special matching edge bearing which must fit well at the upper edge of the tool slide when clamping so as to prevent the holder from being forced away during the operation. ❋ Horst Kth (1990)

What is the rotational speed for cross knurling of knobs of hard rubber with a gripping surface of d = 24 mm and 20 mm width? ❋ Horst Kth (1990)

Figure 8 Spiral knurling tool - clamping with matching edge bearing ❋ Horst Kth (1990)

Straight knurlings are produced by means of straight or hollow knurling wheels (mostly cylindrical) with one wheel only in the knurling holder. ❋ Horst Kth (1990)

Spiral knurling of big widths Institut fr berufliche Entwicklung e. ❋ Horst Kth (1990)

By experience it is known that after knurling the diameter of the workpiece will be approx. t/2 bigger than before. ❋ Horst Kth (1990)

Straight knurling holders are solid and have one wheel (see Fig. 4). ❋ Horst Kth (1990)

All knurling wheels are fixed by unhardened steel pins. ❋ Horst Kth (1990)

Dimensions of the workpiece for any material for hard rubber for brass aluminium, fibre for steel straight knurling cross knurling spiral knurling ❋ Horst Kth (1990)

Straight knurling of small widths on simple cylindrical parts5. ❋ Horst Kth (1990)

Cross knurlings are produced by knurling with two wheels having straight teeth in opposite directions. ❋ Horst Kth (1990)

The spiral knurling holder, the head of which is tiltable, holds two wheels (see Fig. 5). ❋ Horst Kth (1990)

- The straight knurling technique is used for all metals. ❋ Horst Kth (1990)

1. I get my knurling done at the public [lathe] in [Bridgeport]. 2. Please [touch] my knurl. ❋ Deez Nuts On Joe Mama's Face (2010)

"The [knurl] on my iPod is bung, so the volume is stuck full on" or "You need a special knurl to open [the battery] [compartment]". ❋ Gr@w/!x (2011)

Where did you learn how to [knurl], bro? That's a [bitchin'] knurl you did on that metal hammer! That is [gnarly] knurling, man! Ha ha ha ha ha! ❋ Shobuz99 (2021)