Ohmmeter

If the person testing the sensor uses an ohmmeter they will ruin the sensor. ❋ Unknown (2008)

LOS -- if you'd limit the exercise of the enumerated rights to the technologies available at the time of the Constitution, you'd have no M-16s, but also no televangelists, no bloggers, not even Scientology, which relies on a spiritual device akin to an ohmmeter. ❋ Ann Althouse (2007)

Graphical Symbol in full simplified voltage path of a movement or current path of a movement or movement of a wattmeter voltage paths for summation or differentiation current paths for summation or differentiation movement of a two-phase wattmeter with 2 elements movement of an ohmmeter movement of a frequency meter ❋ Klaus Janoske (1991)

Using an 8.5-digit ohmmeter, the demo shows the ability of an FSR device, built on Bulk Metal Foil® technology, to withstand rough handling with no change whatsoever in its resistance value.

The approach presented by the author is much superior to the usual long chunks of braid etc to DC ground to bolts and screws with boasts of how low the ohmmeter reading of the result were. ❋ Unknown (2009)

If you are trying to measure the resistance of pure metal, you are down in the micro-ohms range, and you need a micro-ohmmeter.

One thing you want to keep in mind when purchasing a milli - or micro-ohmmeter is what is the purpose of the measurement.

That's where your Keithley and HP meters shine; their output potential at the most sensitive ohmmeter range is 20 mV.

The transformers and their shield cans luckily are still with the rig - they seem to be electrically OK with an ohmmeter checking for shorts or opens. ❋ Unknown (2009)

Both insulation testers are CAT III / 600V and have a sensitive ohmmeter for checking resistance of motor windings and a programmable timer to perform the dielectric absorption ratio test.

TTI has improved its BS407 micro-ohmmeter by increasing its accuracy at the lowest values of resistance. ❋ Unknown (2009)

If the voltage reading is higher than this, indicating excessive resistance, move the volt-ohmmeter negative lead to the starter solenoid B-terminal and repeat the test. ❋ Unknown (2008)

Always make the volt-ohmmeter connections at the component terminal rather than at the wiring end connector. ❋ Unknown (2008)

Checking continuity with an ohmmeter on known ground pins suggests a cable cross-over or some other inconsistency. ❋ Unknown (2008)

Although it was originally based on electroacupuncture, which involves the use of an ohmmeter to measure the body’s response to the stimulation of the meridians, Bioenergetics now includes the use of a modified biofeedback machine to balance the body both energetically and through the use of appropriate supplements and homeopathic remedies. ❋ Joel Naftali Lee (1999)